Assembly

Before you begin using your kit, a few simple assembly steps are necessary:

  1. Connect the cellular antenna

  1. Find the cellular antenna in your kit. The cellular antenna is a black, 6-inch hinged paddle.

  2. Locate the SMA port marked “CELL” on the top of the T1G.

  3. Insert the cellular antenna into the “CELL” port and screw it until tight.

  4. Rotate and angle the antenna to point up into the air

  1. Connect the GNSS antenna

  1. Find the GNSS antenna in your kit. The GNSS antenna is a circular puck with a long cable.

  2. Locate the SMA port marked “GNSS” on the top of the T1G.

  3. Insert the GNSS antenna connector into the “GNSS” port and screw it until tight.

  4. Place the GNSS antenna in a location with good line-of-sight to open skies.

T1G with attached antennas

T1G with antennas properly attached